We picked up power from the stud under the hood on the fuse box, and mounted the circuit breaker on a small metal tab that a wire harness connector was attached to:
|
|
|
|
|
|
|
A few pictures of a Controller install I did on a 2000 Jeep Cherokee
I sell a kit that makes this installation much easier. It has all you need to hook up the controller (Click here)
For more info, vist the
Jeep Club Web Site
For our install:
We picked up power from the stud under the hood on the fuse box, and
mounted the circuit breaker on a small metal tab that a wire harness
connector
was attached to:
The 12 volt power wire was ran across and through a hole in one of the grommets on the fire wall. It connects to the Black wire on the Tekonsha Brake controller.
The Blue wire that goes back the the trailer plug was wrapped up in
the dash above the park brake pedal. It connects to the Blue wire on
the
Controller:
The Brake light switch on this truck was the White wire with a tan
stripe. (I have found some later
Jeeps, the wire was purple with a tan stripe ) Find the
brake light switch (on the pedal), and you will see that the harness
from
it goes forward to the firewall. Peel back the harness wrap, and you
can
see the wires. Finds the Small white wire with the Tan tracer Stripe.
With
a side tap, (Scotch lock) tap into this wire for the Red Wire on the
Tekonsha
Brake control.
|
|
|
|
|
|
|