R and P Carriages


Home Trailers Parts Rentals Help Section Contact Us
2007 Jeep Commander Brake Controller Installation
(Other Years May Be the Same or Similar)

Please visit my general install page for overall instructions

I sell brake controllers, so please, if you need one click here! We keep Prodigy P2 Brake Controllers in Stock Regularly!

"Standard" Wire colors to the controller (Tekonsha and others):
- Black, Battery Positive to controller
- White, Negative Ground for Controller
- Blue, Brake feed from controller to Trailer plug at back of truck
- Red, tap into truck Brake light switch signal to tell controller to apply brakes


Remember, the above colors are just a GUIDE. your colors may be different, read the instructions!


2007 Jeep Commander

2007 Jeep Commander

We tapped into the white wire with the tan tracer for the brake light signal (red wire is from the controller)

2007 Jeep Commander

2007 Jeep Commander

We ran a power feed wire from the 10mm main power stud nut on the fuse panel under the hood, to a 15 amp circuit breaker we mounted in the fuse panel, then out to the firewall. We drilled a small hole in the rubber grommet (and sealed with silicone when done) to pass the power wire into the dash area to power the controller.

2007 Jeep Commander

2007 Jeep Commander

2007 Jeep Commander

 

 


Home | Trailers | Parts | Rentals | Help Section | Contact Us
Questions? Email the Webmaster!
Copyright© R and P Carriages 2015