R and P Carriages | Cargo, Utility, Dump, Equipment, Car Haulers, and Enclosed Trailers in Chicago, Ottawa, Dekalb, and Joliet, IL

1996 to 2009 Dodge Trucks (with tow package)

"Standard" Wire colors to the controller (Tekonsha and others):

    • Tekonsha and others
    • Function
    • Black
    • Battery Positive to controller
    • White
    • Negative Ground for Controller 
    • Blue
    • Brake feed from controller to Trailer plug at back of truck 
    • Red
    • tap into truck Brake light switch signal to tell controller to apply brakes 

Remember, the above colors are just a GUIDE. your colors may be different, read the instructions!

Installing a brake control unit isn't very difficult. This task is made even easier if your tow vehicle is a late model and comes with a 7 Way Connector as part of the towing package.

In this case, installation is as simple as mounting the brake controller in a convenient, easy to reach place, usually under the dash, just above your right leg and connecting the wires from the brake control to the wiring harness and then plugging the harness into the harness located under the dash.

Most newer vehicles equipped with towing packages are now providing a wiring harness which looks similar the ones in the picture below depending on the make of your vehicle: 
 

Dodge vehicles  have an independent and movable wiring harness. On some dodge vehicles, the harness is found loosely stuffed under the dash above the driver's right leg. And on others, it can be found attached to a module above the driver's left leg. The harness connector is often blue as shown in the picture below. You must have the factory plug harness to plug in (I sell these, if you need one, hint, hint)

Then it is just a matter of connecting the harness up to your brake controller, according to the wires colors above using butt connectors, and then plug it in. Mount the controller where your want it. I prefer to have it on the right side of the steering wheel, within reach of my right hand. Just screw the bracket right into the plastic dash panel (I know, it hurts!)

Now, under the hood, is the fuse box. You MAY need to install the fuse and or relay for your trailer brakes. You will have to look in you owners manual to find the fuse size and location, and any relay you may need to install. Sorry, they are all different. Often your truck came with a extra fuse. I have found them to often be the large square type fuse, and is it labeled the "trailer" on the underside of the fuse box lid.